Unable to add channel when defining capture source

[ktalley]

Just installed latest version (v0.97.13) -- when I go in to define my capture source thru Config, I can't seem to get any channels to "stick". I can try to manually add a single channel, but when I click Okay, nothing is in my list/grid. Also, if I do the EPG update (using Zap2It), it goes thru the steps correctly (parsing, etc.), but then nothing in the list! What gives? This worked fine in previous version (actually, this is the same hard drive with a fresh XP re-install -- could something have been left over in my previous GBPVR folder that is causing issues?)

Any ideas on what I can try? Logs, etc?

Thanks!
ktalley

[sub]

what type of capture device do you have?

[ktalley]

Sorry, I guess that would have helped in the original post!

PVR-150 capture card -- using "S-Video, external tuner" as my Source (this is connected to a DP311 Dish Network receiver). I'm almost sure this is how I had it set up previously (when it worked fine).

I am curious, however (and this was true previously also) -- why is it that when I check "show only devices detected in this computer" that PVR150 disappears? I noticed that in prior version(s), but I just left it unchecked and selected PVR150. No biggie -- just curious...

Thanks in advance for any advice...

[sub]

Just installed latest version (v0.97.13) -- when I go in to define my capture source thru Config, I can't seem to get any channels to "stick". I can try to manually add a single channel, but when I click Okay, nothing is in my list/grid. Also, if I do the EPG update (using Zap2It), it goes thru the steps correctly (parsing, etc.), but then nothing in the list! What gives? This worked fine in previous version (actually, this is the same hard drive with a fresh XP re-install -- could something have been left over in my previous GBPVR folder that is causing issues?)

Any ideas on what I can try? Logs, etc?

Reproduce the problem, then zip and attach the config.exe.log and config.exe-native.log and I'll take a look.

[ktalley]

Got it -- sorry for the bother...

I uninstalled, deleted the GBPVR installation folder, and re-installed. Everything works fine now. Since I had re-installed XP on my existing hard drive (that had prior GBPVR installed), I really didn't even think about the fact that I might need to uninstall old version first (or delete the folder in this case -- since this was a fresh registry, etc.).

Sorry to have wasted a few minutes of your time. Thanks for the quick response, Sub...

GREAT software...

ktalley