2004-06-16, 10:33 PM
Hi,
First I want to say - thank You for the fine piece of software.
I just bought the Hauppauge WinTV USB 2.0. And the same day you released the version 0.18 of the software with support for my new hardware! Super nice.
I have tried several times to use my laptop as PVR by marking a few programs in TVguide and then closing the user interface.
The service is ofcourse running.
Then I make my computer go into standby mode.
When I get back after the programs has been sent, I see that the recorded video is distorted like the tuner can't find H or V sync and the colors go mad. Like a really bad antenna.
This does not happen if I leave the computer running so it doesn't have to resume from standby.
Comp is Dell lattitude 840
internal usb 1.1 port
the driver for the hauppauge is version: 2.52.1.21351
I will try and see if there is a newer driver for the hardware and maybe move the usb to a PCMCIA usb2.0 card.
Keap up the good work!!!![[Image: wink.gif]](http://gbpvr.com/iB_html/non-cgi/emoticons/wink.gif)
First I want to say - thank You for the fine piece of software.
I just bought the Hauppauge WinTV USB 2.0. And the same day you released the version 0.18 of the software with support for my new hardware! Super nice.
I have tried several times to use my laptop as PVR by marking a few programs in TVguide and then closing the user interface.
The service is ofcourse running.
Then I make my computer go into standby mode.
When I get back after the programs has been sent, I see that the recorded video is distorted like the tuner can't find H or V sync and the colors go mad. Like a really bad antenna.
This does not happen if I leave the computer running so it doesn't have to resume from standby.
Comp is Dell lattitude 840
internal usb 1.1 port
the driver for the hauppauge is version: 2.52.1.21351
I will try and see if there is a newer driver for the hardware and maybe move the usb to a PCMCIA usb2.0 card.
Keap up the good work!!!