2007-01-02, 12:09 PM
...when mapping digital to EPG.
This worked before, I tried using GBPVR to watch TV yesterday and it was working fine, today I use it and I get a blank/black screen with no error message. I've tried going through the config, updating EPG, etc.
I've completely removed and re-installed the software to no avail.
The problem seems to stem from it thinking that when 'scanning' for channels the channel strength is -20 - therefore it doesn't find anything. The antenna, and signal should be fine as I'm about 1/2 a mile from the mast!
Anyhow, any ideas would be greatfully appreciated.
Thanks.
This worked before, I tried using GBPVR to watch TV yesterday and it was working fine, today I use it and I get a blank/black screen with no error message. I've tried going through the config, updating EPG, etc.
I've completely removed and re-installed the software to no avail.
The problem seems to stem from it thinking that when 'scanning' for channels the channel strength is -20 - therefore it doesn't find anything. The antenna, and signal should be fine as I'm about 1/2 a mile from the mast!
Anyhow, any ideas would be greatfully appreciated.
Thanks.