Divide by Zero Error on Live TV

[gundo]

Hello,
Ive just installed GB PVR for the first time, im using a Freecom DVB-T Usb stick, which GBPVR autodetects (I have installed the BDA drivers from Freecom).

I have successfully performed the channel scan and epg update, however whenever I try to watch the Live tv option, I get an error message saying :

'Error attepmted to divide by zero'

I have tried scrolling through the zillions of pages on this forum to see if it has already cropped up but couldnt seem to find it.
Can anybody help?
Thanks very much,
Mark
thetastychippy@yahoo.co.uk

[sub]

zip and attach the logs and I'll take a look.

[gundo]

Hi,
thanks for the superfast reply, I have attached my logs ( I hope they are all there).

Thanks a lot for your help,

Mark

[sub]

I'm not really sure, but I'd suggest trying different combinations of audio and video decoder.

[gundo]

Hi again,

thanks for looking, Ive tried all different combos and still getting the same error.

When I run the BDA mux checker it says :
'NO MULTIPLEXER FILTERS WHERE FOUND ON YOUR MACHINE'

Has this got anything to do with it?

Something must work as when I do the channel scan I can see live tv in the small disply in the top right corner.

Thanks,
Mark

[sub]

No, it wont be related to the BDA mux. These are only used when you're recording.

[gundo]

Hi,

Are there any other software decoders I can try installing that may solve my problem?

Thanks,
Mark

[sub]

Yes, there are lots of video and audio decoders out there, but I dont have a list of URLs for you. If any one is going to do the search, it might as well be you.