2007-03-19, 09:09 PM
I'm not sure if this is expected behavior or not but I can't seem to figure it out. In the screen shot I have three programs circled. Each one does not have lines separating the programs. It's also the same for channels 12, 13, and 18 in that screen shot. I've noticed this the past few builds. It doesn't matter what channel it is and it doesn't matter what skin is used. On channels 14 & 19, there is a line separating the programs shown.
Search Results: noting this thread about a similar issue, the pre & post paddings in the search results show zero. I have them set to 1 minute in the config app.
I use the table results when searching. Can you put a line separating each result? It's not a big issue when I'm using a 1024X768 screen but when using a 1600X1200 LCD, I can't really tell if I'm checking the box for the show time I want. See second screen shot.
Thanks!
Search Results: noting this thread about a similar issue, the pre & post paddings in the search results show zero. I have them set to 1 minute in the config app.
I use the table results when searching. Can you put a line separating each result? It's not a big issue when I'm using a 1024X768 screen but when using a 1600X1200 LCD, I can't really tell if I'm checking the box for the show time I want. See second screen shot.
Thanks!