Log file fills up the hard drive

[sub]

I've had a look in your database, and it seems pretty screwy. You have a duplicate set of channels. The PVR350 is hooked to one set, and the PVR500 capture sources are linked to the other. This probably happened some time around your switch from Zap2it to Schedules Direct.

The easiest fix up is to delete you gbpvr.db3 file, then run the config app and recreate all three capture sources. Set the capture source device numbers as I described earlier in this thread. I'm sure it'll work on the first try.

[boxxed]

I wished it did work on the first try... I got the response. So then I deleted the gbpvr file again rebooted and the I just added the 500 in the config application and it gave me the same response. Let me know what you think...

Thank you very much..

[sub]

Can you email me you database again so I can see if the same thing happened?

[boxxed]

i did

[boxxed]

Go ahead and delete this whole thread. I put the cards in a another system that is basically the same as the one I was having problems with. I installed the 500 worked just fine, then I installed the 350. It seems to work just as you intended it to. Thank you so much for your time and effort. I know supporting this board is just like a full time job.

[sub]

No worries, glad you got it sorted.