2007-12-20, 12:59 PM
I have a Freecom DVB-T USB stick that gets identified by GBPVR as a type 4. It installs just fine and when I scan for channels, all is good. The light on the stick turns green, the preview windows starts playing, and a couple dozen channels are found. Whilst channel scanning, the signal strength and quality during the scan look good (several thousand in signal strength, quality always above 80). When I go into PVRX2 and tune to a channel though, it then tells me that no signal is found and the light on the stick stays yellow. In the "no signal" message that comes up, the strength bar is completely full and the quality bar is completely empty. This happens for all channels except Sky News and Sky News Sports, which actually do tune in fine. If I then go back into config to the map channels section, the preview window no longer plays a preview for any of those same channels. If I then do another channel scan, all looks good again during the scan, but I have the same problems afterwards.
I also have a Hauppauge Nova-T stick and it works fine, which tells me that there aren't problems with MPEG-2 decoders or muxes (using the DVR-MS mux with NVidia PureVideo decoder).
Logs attached.
I also have a Hauppauge Nova-T stick and it works fine, which tells me that there aren't problems with MPEG-2 decoders or muxes (using the DVR-MS mux with NVidia PureVideo decoder).
Logs attached.
