2008-11-16, 08:09 PM
I have a Hauppauge HVR-2250 and am trying to record from the two s-video inputs using GBPVR v1.3.7 under XP. I can successfully access the s-video input (s-video1) mounted on the main board. However, I cannot configure GBPVR to get the correct audio for the second s-video input (s-video2) mounted on the external connector board. GBPVR will get the video (but not the audio) for the s-video2 input even experimenting with all the various svideo and composite capture sources available to the config tool.
Note that some config settings will output the audio from the s-video1 input to s-video2, but no settings access the audio from s-video2. I currently have the external connector board connected into the motherboard connector closest to the main board mounting bracket, but also tried the other motherboard connector unsuccessfully. I am able to access both s-video inputs using Hauppaugeâs WinTV application, but prefer to use GBPVR.
A zip of my log and ini files is attached and I would appreciate any suggestions on how to access the s-video2 video and audio for recording.
On another note, my recording rates are way below the 12000 CBR specified for the HVR-2250âs hardware encoder at http://www.hauppauge.com/site/support/su...intv6.html. Bitrate Viewer shows a nominal bitrate of 6000 VBR even recording in GBPVR with a custom setting set to 12000 CBR. Iâve seen another user question the maximum bitrate for the 2250 so this may not be an issue with GBPVR. Can anyone suggest config settings in GBPVR to maximize CBR and VBR output for the 2250?
Thanks for any help.
Note that some config settings will output the audio from the s-video1 input to s-video2, but no settings access the audio from s-video2. I currently have the external connector board connected into the motherboard connector closest to the main board mounting bracket, but also tried the other motherboard connector unsuccessfully. I am able to access both s-video inputs using Hauppaugeâs WinTV application, but prefer to use GBPVR.
A zip of my log and ini files is attached and I would appreciate any suggestions on how to access the s-video2 video and audio for recording.
On another note, my recording rates are way below the 12000 CBR specified for the HVR-2250âs hardware encoder at http://www.hauppauge.com/site/support/su...intv6.html. Bitrate Viewer shows a nominal bitrate of 6000 VBR even recording in GBPVR with a custom setting set to 12000 CBR. Iâve seen another user question the maximum bitrate for the 2250 so this may not be an issue with GBPVR. Can anyone suggest config settings in GBPVR to maximize CBR and VBR output for the 2250?
Thanks for any help.