2010-10-18, 01:31 PM
Following on from my hmmmmmm, I've had a go at writing a utility to edit the channel name in the xmltv files.
Its attached, and I would appreciate if someone could give it a sanity check.
The syntax is:
xmlcnc [-q | -v] XMLTVFileName TextToRemove [TextToInsert]
Example: xmlcnc c:\listings.xml "(Satellite/Cable)"
Options -q and -v are quiet, show no messages, and verbose, show details of cleaned names.
The TextToInsert is optional and means it can edit the channel names.
Its attached, and I would appreciate if someone could give it a sanity check.
The syntax is:
xmlcnc [-q | -v] XMLTVFileName TextToRemove [TextToInsert]
Example: xmlcnc c:\listings.xml "(Satellite/Cable)"
Options -q and -v are quiet, show no messages, and verbose, show details of cleaned names.
The TextToInsert is optional and means it can edit the channel names.