Realtek 2840 (DVB.C) support

[rvs75]

This shouldn't be happening.

What u should make sure is that u install the appropriate driver for DVB-T2 or DVB-C as appropriate.

For DVB-T2, use the following:
https://dl.dropboxusercontent.com/u/9625...140529.exe

For DVB-C, use the following:
https://dl.dropboxusercontent.com/u/9625...140529.exe

According with the Astrometa support, the drivers are identical, the difference is only a key in the registry !!!

Code:

Dear User,

The driver is loaded and started only when the dongle is plugged.
And the driver will read this flag from registery on start.

Best Regards,

Support
Astrometa

From: rvs75
Sent: Wednesday, May 28, 2014 1:32 AM
To: Support
Subject: RE: Downgrade drivers

Hello,

Work only if i restart after apply the .reg.
It is not very usable Emoji.

Sincerely,

Hervé.

From: support@astrometa.com.tw
To: rvs75
Subject: Re: Downgrade drivers
Date: Tue, 27 May 2014 10:18:27 +0800

Dear User,

Please use attached files to switch between DVBT or DVBC BDA driver.
Accept if Windows asks for your permission.

This problem is caused by driver build 140425 for DVBC, the flag was not
reset by DVB-T2 driver.

Let me know if it is ok.

Best Regards,

Support
Astrometa



From: rvs75
Sent: Tuesday, May 27, 2014 4:39 AM
To: support@astrometa.com.tw
Subject: Downgrade drivers

Hello,

I try the DVB-C drivers and it work for third-paty software but only in DVB-C and not in DVB-T/T2.
I downgrade the drivers to try to see DVB-T channels but, the key is always recognize like a DVB-C key.
How i can downgrade properly to see DVB-T channels in third-party software ?

Sincerly.

Hervé

[Reddwarf]

I know this is an old thread, hijacked by the Astrometa issue, but did you ever find a dvb-c driver for the Realtek 2840? I need one too...