Clock Problem

[jcjefferies]

On several occasions the X-NEWA clock has not updated. At the end of watching a recording X-NEWA displays the time when you started watching the recording and usually takes a minute or two to refresh to the correct time. However on several occasions the clock displays the original time after playing several recordings.

Last night X-NEWA still displayed the time 19:04 when I shut the client down at about 19:55 several minutes after I stopped watching a recording. When I returned home just before 23:00 and switched on the client it was still showing the time as 19:04. Thinking I must not have shut down the client I rebooted it and again the time was still 19:04 but because this client does not autostart X-NEWA I noticed that the XBMC time was correct.

Chris

[mvallevand]

Last night X-NEWA still displayed the time 19:04 when I shut the client down at about 19:55 several minutes after I stopped watching a recording. When I returned home just before 23:00 and switched on the client it was still showing the time as 19:04. Thinking I must not have shut down the client I rebooted it and again the time was still 19:04 but because this client does not autostart X-NEWA I noticed that the XBMC time was correct.

X-NEWA just uses normal xbmc skin functions for the data and time. Since you shut it down and restarted, is that with the web client? I so try the Exit menu option to reset the client session.

Martin

[jcjefferies]

I may have found the problem! This morning I noticed XBMC time was an hour behind X-NEWA time and if I changed the clock in the BIOS it was changed back when Openelec booted. On both clients I am using the Region is set to UK but the Timezone below was unset I think greyed out giving the impression that it wasn't needed because the "Region" was set. Setting the Timezone country to Britain(UK) seems to have sorted that problem so will see over the next few days if it has sorted out the time update problem. On one client "Exit" on the X-NEWA menu has never worked since Gotham was installed but suddenly this morning after the Timezone change it now works!!

Chris