Recording - Colours heavily saturated

[onestar]

I have a question to see if anyone has experienced this.

I have a 350 and 150 in the system. Everything seemed fine for a few days.

Then I downloaded the hauppauge tweak tool, and added settings (default) for the 150.

Now this is guessing given the different numbers involved, that when I recording on the 350 everthing is fine (saturation set at 34). When I record on the 150 its fine too (saturation at 80). But if after that I record on the 350 the 150 settings are used ? and the saturation kills the recording.
I tried testing this, and think this is so, but it seems a 1 shot test, since the system blue screens after a while. It might be contrast or saturation.

So anyone else see this? I have deleted the settings in the 150 registry to see if the problem happens again.

I am going to get murdered here, this is the 3rd week a particular show's recording has gone bad (each week different reason (including replays)) DOH!

[spyder40]

Onestar,

What tweak tool are you referring too? I have a problem with my USB2 where the recordings are a little saturated on the red side.

[stefan]

I think the tweak tool thread can be found here:
http://forums.nextpvr.com/showthread.php?t=4791
Not sure if it supports the USB2 device, though.

[onestar]

I think the tweak tool thread can be found here:
http://forums.nextpvr.com/showthread.php?t=4791
Not sure if it supports the USB2 device, though.

Thats the one

[onestar]

You can install MS Graphedt and make sure your at the default level. ...... Make sure you have internal FAN blowing on those two capture cards I am sure with your video card it's "getting hot in here" like that rap song!

How do you check that its at default level?

Yeah was wondering about heat, machine seems okay compared to one I have to leave the lid off, but its always a concern. Thats why I was hoping this set of events may have happened to someone else - and it was a software issue - not hardware