2005-11-09, 07:50 AM
Hi guys
I just installed xrecord on my system and started to have a bit of a play, looks like what i've been looking for.
Unfortunatly, I didn't setup all the config options and now I get the following msg:
"Microsoft .NET Framework
An unhandled exception has occurred in your application. If you click Continue, the application will ignore this error and attempt to continue. If you click Quit, the application will be shut down immediately.
Specified argument was out of the range of valid values.
Parameter name: '0' is not a valid value for 'index'"
It then goes into greater detail, much greater detail :-(
I have run the uninstall for xrecord and this fixes the problem, until I reinstall and get the same message
Any Ideas??
I just installed xrecord on my system and started to have a bit of a play, looks like what i've been looking for.
Unfortunatly, I didn't setup all the config options and now I get the following msg:
"Microsoft .NET Framework
An unhandled exception has occurred in your application. If you click Continue, the application will ignore this error and attempt to continue. If you click Quit, the application will be shut down immediately.
Specified argument was out of the range of valid values.
Parameter name: '0' is not a valid value for 'index'"
It then goes into greater detail, much greater detail :-(
I have run the uninstall for xrecord and this fixes the problem, until I reinstall and get the same message
Any Ideas??