No LiveTV in timeshift mode when using different users

[LilY0da]

OK, I think I narrowed it down
I installed the software while logged in as administrator.
I can view LiveTV in timeshift mode when I'm admin
However, when I switch to any other user, even a user that is part of the administrator group like my domain admin account, when I try to watch LiveTV on the PC, GBPVR stays stuck in "starting timeshift mode", jumps up to 100%CPU and then does nothing, until I kill the task

I gathered clean logs in both cases, and I think the error is towards the end of the gbpvr-native log, where it says it can't find a "GBPVR parser" when I'm logged as any other user.

Suggestions? Ideas? Solutions?

[robplatt]

you sure the path to your live tv buffer is viewable by your user account? why not go into your user account and set it as admin

[sub]

You could try running the following commands, then try again.

regsvr32 /u "c:\program files\devnz\gbpvr\GBPVRParser.ax"
regsvr32 "c:\program files\devnz\gbpvr\GBPVRParser.ax"

[LilY0da]

regsvr32 "c:\program files\devnz\gbpvr\GBPVRParser.ax"

Bingo, that works!
Anyway to make that registered for all users on a machine?

[sub]

Running the two commands I mentioned above should register it for all users.

[LilY0da]

Oh ok. Haven't tried with a 3rd user yet, but I will.
But I meant to add that to the install process for a future release

[sub]

But I meant to add that to the install process for a future release

Yes, I was aware of the issue and there is already something like this in the next release.