Setting up channel source.

[Dougal]

I have a WinPVR150. But my channel setup is special. You see, my Dish Network reciever has two outputs, and one goes to my tv, the other to my computer. The thing is, I don't have an IR blaster, nor do I need one. I change the channelw tih my remote and it changes the channels on my computer. But, it doesn't see the input. When I do the Tuning Assistant, it find the single channel, but I can't configure it to pick it up on GB-PVR.

Can I get a step by step thing on how to set this up?

[Dougal]

Any help?

[tkgafs]

Any help?

how are you connecting your dish to the pvr 150 ?

are using the RF input or the Svideo or RCA composite input ?

you need to tell gbpvr where the signal is coming into the pvr150

this is done in the gbpvr config application

where you set up the capture sources

I cant remember the exact screens as I'm at work just now

Tkgafs

[Dougal]

Coax. I've told it to, but it still doens't work.

[User]

In the config application you need to add a Capture Source for "Fixed-Channel, External Tuner" and set the fixed channel to either 2 or 3, whichever your set top box outputs to. That should fix you up for using the coax input.

[Dougal]

The config crashes when I click OK... My EPG is set to none, like it should be, right? And Direct Recording Plugin.

[Dougal]

...

[sub]

The config crashes when I click OK...

Reproduce the problem and attach you config.exe.log and I'll take a look.

My EPG is set to none, like it should be, right?

It wont be the cause of your crash, but since you are using Dish Network, you should set it to use the zap2it epg.