Same Channels after tenth channel

[Dady]

Hi All,
I have a strange problem with channel settings: I have created a Capture Source (PWR 350) and I have added some channels. When I go to the Live Tv I can see first nine channels (that are differents), but from ten channel to twenth channel (for example) I can see ONLY THE SAME CHANNEL....

I am in Italy (Control panel>Regional Settings on Italy).

Can something help me??? I have tried freqcopy, too...

Thanks a lot!!

[Gandalf]

Hello!

I cant help you but im curious cause i have the same problem
i have 11 channels installed but i can only se 10 different channels.....and if i try to record on the 11:th channel i only
get the channel before not the one i supposed i was recording

Hope we get some help

[sub]

Can you try going to a couple of channels below 10, then try a couple over 10. Then email me your logs and confirm in the email which channels you tried to view and in which order.

[Dady]

Ok...
I have founded the solution... I have retry to use freqcopy with region code 33, 39, 0 and changing cable and antenna and finally all is ok!!! (i don't remember with witch combination......). Howeher that's works !!!!

For testing I have initially installed one hundred channels in my Capture Source, then, when everithing was ok, I have disabled the empty channels (gray, or with no signal)....

However, thanks to all !

Dady