DisEQc support

[spyder40]

Sub,

Now that you have added MultiDecc support I'm looking to get a DVB-s card. My current setup is two dishes (110/119 and 91) and Chieta 4/1 DisEQc switch going to a Viewsat Ultra. From searching, you mentioned you use a Twinhan card with a switch successfully. Which model? And are you working on getting any other cards going with a switch? I was thinking about a 102g or a Hauppauge.

[sub]

Now that you have added MultiDecc support I'm looking to get a DVB-s card. My current setup is two dishes (110/119 and 91) and Chieta 4/1 DisEQc switch going to a Viewsat Ultra. From searching, you mentioned you use a Twinhan card with a switch successfully. Which model?

I'm using a VP-1030A, though it probably works with most other Twinhan models aswell.

I've only got limited exposure to different diseqc switches though, and have only used the 4 way diseqc switch I one. I know there are few standards used, so you mileage may vary if you're not using the same switch as me.

And are you working on getting any other cards going with a switch?

Basically diseqc support isnt covered in the BDA spec so each manufacturer does it a different way, requiring me to implement specific support for those cards I want diseqc support with. Diseqc support should currently work with the Twinhan cards, Hauppauge cards (HVR3000/4000, Nova-S Plus etc) and FireDTV DVB-C devices, though I've done most of my testing with the Twinhan device.