ShowAnalyzer Launch

[scotty]

I switched recently from Comskip to ShowAnalyzer. In the configuration, I selected ShowAnalyzer instead of comskip for commercial removal, but ShowAnalyzer is not launching. Any ideas?

[sub]

Do you have a PostProcessing.bat file? If so, then this is used instead of directly launching ShowAnalyzer. You can just run ShowAnalyzer from the PostProcessing.bat if you need to.

[nia]

I've been using SA for years with no problems. It's only configured in the config-application. I do not have a Postprocessing.bat (anymore).

Have you selected the option to do it during recording? If so, try to leave it 'till after recording has completed. Otherwise, I would go with sub's advice. That worked for me in the past as well.