2008-04-13, 05:35 PM
I am using a PVR 350 and after reading many posts online here and other websites was able to configure and have Closed Captions recorded into the MPEG file. By trial and error and some more reading, that after the PC is rebooted [unfortunately that is needed occasionally 
], that the very first use of the card does not include closed captions. If I either record a show or view live for even a few seconds, then the next time of recording or viewing is fine.
So my questions are:
a. Does anybody have any suggestions or ideas as to why or ideas to make it work the first time?
b. If it is not solveable, then I thinking of a workaround that using the new schedule.exe to record a 10 sec clip after reboot. Not sure where would be the best place to put this, perhaps into the Run section of Registry under HKLM\Software\Microsoft\Windows\CurrentVersion\Run ... any ideas?
The main reason I want to have this automated is that the wife likes closed captions and the above gets a little complicated.
Paul
(Canada)
], that the very first use of the card does not include closed captions. If I either record a show or view live for even a few seconds, then the next time of recording or viewing is fine.So my questions are:
a. Does anybody have any suggestions or ideas as to why or ideas to make it work the first time?
b. If it is not solveable, then I thinking of a workaround that using the new schedule.exe to record a 10 sec clip after reboot. Not sure where would be the best place to put this, perhaps into the Run section of Registry under HKLM\Software\Microsoft\Windows\CurrentVersion\Run ... any ideas?
The main reason I want to have this automated is that the wife likes closed captions and the above gets a little complicated.
Paul
(Canada)