Hauppauge WinTV Nova-T 500 scanning problems

[simeonipicker]

Hi,

First post, first time user of GBPVR.

I apologise if any of the following is unclear, I am at work and not by my HTPC so I'm doing it all from memory!

I have done as follows:

- Installed Vista along with drivers and Nova-T 500 drives/software
- Installed GBPVR
- I have then followed the Wiki guide to scanning for channels, and it picks up nothing.

I know the card works fine with the antenna because I can scan for all Freeview channels through the normal Wintv software.
When scanning through GBPVR, I tick the box saying only show installed devices and I get 5 or 6 options, I have tried each one but none will pick up channels. An image flashes up from time to time during the scan(usually once or twice) and I do get "Strength:1300" so it is seeing some sort of signal but it just cant seem to pinpoint any specific channels at all.

I have tried scanning on the "all regions" drop down box with no luck. A fellow worker who was experience with mythtv told me that I should select "rowdridge" location in "Southern england" drop down as that is the closest point to me. I tried this and the same thing happened.

I am getting so frustrated! Any help would be much appreciated. Please ask if you need any more information.

Regards

Simon

[cdldt]

Do you have a Nova-T-500 99xxx or a Nova-TD-500 84xxx ?

See the following page:
http://www.quantexzone.com/faq/wintv_faq...-t-500.htm

[simeonipicker]

It's very new so I believe the 84xxx

Regards

[simeonipicker]

When ticking the box "View on installed devices"(Or something like that) it shows WinTV Nova-TD 1 and WinTV Nova-TD 2 among other options. I have tried these and that still doesnt give me the channels :-(

[sub]

Do a scan, then zip and attach the config.exe.log and config.exe-native.log and I'll take a look.