HVR-1600 ATSC No Channels Found

[tsangc]

Hi folks,

I recently upgraded to an HVR-1600 and have the NTSC Analog working properly under GBPVR. But I've got a bit of a problem with the ATSC side and I hope you guys can help me out:

I attached an antenna to the ATSC connector and got several broadcast ATSC channels working using WinTV6, they detect with solid signal strength and I get picture/sound.

I followed the instructions on ATSC HD recording ("Configuring OTA ATSC HD channels (USA)") and set up a second capture source as the HVR-1600 ATSC digital tuner, configured a second XMLTV source for listings. I clicked the “Map Digital Channels to EPG Channels” window and the scan process began. During the scanning process, GBPVR will "detect" channels with strength and quality, but show no preview. When done, it says "No channels found"

Is there something I'm missing? Thanks in advance for your help!

Calum

[sub]

Can you do a scan, then zip and attach your config.exe.log and config.exe-native.log files?

[tsangc]

I've attached them here along with a screenshot of the scan process where it found a signal. Thanks for taking a look at them!

Calum

[sub]

2009-01-11 01:56:32.054 VERBOSE FindFilterByName failed to locate filter: GB-PVR PSI Parser

Try running ReRegisterFilters.bat, then try again.

[tsangc]

That did it, thank you! I have managed to get it to record ATSC OTA HD into a TS file!

Now just to figure out how to play it back-- I think my MPEG2 decoder or rendering isn't set up properly. They decode MPEG2 properly from the ATI eHome and the 1600 Analog.

Thanks again for your help. I'm halfway there now.

Calum

[tsangc]

And now, after forcing GBPVR onto using ffdshow for decoding, ATSC playback works great.

Calum