Eventghost channel changer settings help

[vskatusa]

Hi,

I have installed eventghost per this wiki.

The keys seems to work. UP , DOWN etc however no luck with channel changer.

BTW, I use the MCE 2005 remote with receiver.

I have the following settings but the channel changer does not work - Can somebody help me out

[sub]

A channel changer is used for controlling an external set top box. Is that what you're trying to do? or a you just trying to use an MCE remote to control GB-PVR?

[vskatusa]

A channel changer is used for controlling an external set top box. Is that what you're trying to do? or a you just trying to use an MCE remote to control GB-PVR?

Yes.

I was using HIP with success but off late this is not working.. Switched to EventGhost and so far very good - All the keys are working fine except for channel changer functionallity.

Any help would be appreciated.

Thanks

[sub]

Start live tv, then try changing channels a few times with the up/down buttons, then post the pvrx2.exe.log and pvrx2.exe-native.log and I'll take a look.

[vskatusa]

Sure... Please find the logs enclosed.

FYI, derpressing the UP and DOWN arrow keys did not change any channels in the LIVE TV.

[sub]

2009-05-31 18:23:28.234 VERBOSE [1] Running: C:\Program Files\EventGhost\EventGhost.exe 100
...
2009-05-31 18:23:37.171 VERBOSE [1] Running: C:\Program Files\EventGhost\EventGhost.exe 101
...
2009-05-31 18:23:41.546 VERBOSE [1] Running: C:\Program Files\EventGhost\EventGhost.exe 100

It looks like GB-PVR is living up to its end of the bargin by running the executable you specified, and passing the channel number. It sounds like things are going in side EventGhost somewhere.

[vskatusa]

sub, thanks!

Maybe there are some parameters I need to include!

Probably somebody can share the parameter's that is being used in eventghost setup