Dvb-S and Dvb-T tuner. More help please

[Waynesm]

I have achieved my Dvb-S,Hauppague USB 2 Nova, set up but when I attempt to set up my second tuner,
Pinnacle 73e,
which used to be my primary set up and I know works, Saves setup but does not update Epg hence no mapping.
Appears to load but at the end does not display channels to be mapped with consequence error message which says after attempting to map
"GB-PVR was unable to display the Bda device you have configured. Check the device is configured properly, and is not already in use.(Reason: Failed to locate configured BDA configured capture device)"
The 73e woks with original software (far inferior to GB-PVR) and I cannot see what I am doing wrong.
Thanks in advance for any help.
Waynesm

[sub]

You need to have them both set as device #1, since they use different drivers.

[Graham]

Forgive me if I'm stating the bleedin' obvious ... you need to select an EPG source for each tuner. Posting the logs might shed some light.

[Waynesm]

For others in similar situation do not assume 2nd capture card is no 2 if using dvb-s as one source and dvb-t as second (i assume vice versa)
I was changing 1 to 2 in config when I should not have,in other words default settings were correct, and my logic was incorrect.
All good am happy.
Thanks again Sub for advice not to mention the brilliant software.
Waynesm