Comskip autoskips works for first few skips, stops working, and status bar goes green

[jksmurf]

This is a problem I have been having for a while, especially on long recordings like movies (1 hr shows seem unaffected), and almost exclusively on FTA channels. I always use a PCH-A100 to watch them, almost never on the PC.

What happens is this:

1. Comskip autoskips works very well for the first few skips, then stops working.
   
2. The status bar (when I press the blue button on the remote) is green up to the cuts and gray to the end of the show, except where the comskip cuts are shown as black bars, all as it should be.
   
3. At the same time as it stops working, when pressing the blue button, I note that the green progress bar goes green ALL THE WAY to end, even though I am only part way through the show.
   
   The attached logs might not show much as it happened last night. I will try and capture a long one again if I watch a movie.
   

Would a broken timeline on long files do this?

k.

[mvallevand]

Could you duplicate the problem and try the logs again. As you expected these just show that you ran the photo screen saver all night.

Martin

[jksmurf]

Will do. Just need to find time to watch a 2hr movie midweek ...