NPVR 311 IR Remote Problem

[crossnet]

Hi Sub,

Just tried 311 and my install (upgrade) went fine. Thanks for all your hard work.

But, I do have one serious problem (WAF). I cannot control the main menu functions with my remotes. The mouse and keyboard work OK, but the top level menu commands from the remote don't work. It's seems to be only the top level commands. If I start a video (live or recorded) with the mouse, some of the remote commands do work. I can play, stop, skip, but I can't exit back to the main menu.

I'm using the standard Hauppauge IR remote SW and receiver connected to a 2250 on Win7. I've done the simple things, reinstalled the IR driver and restarted without success. It seems that the menu functions are much slower than with ver 262. Could this be a response time issue? Any thoughts?

Logs attached.

em

[Graham]

Has the irremote.ini lost the entries needed for npvr.exe ...

http://www.nextpvr.com/nwiki/pmwiki.php?...ttonRemote

[Zeb]

Possibly related to new "Getting Started" sticky thread, post #3 item 7:

"NOTE: the upgrade overwrites KeyMappings.xml; if you made changes in there, be prepared to re-apply the changes after upgrade"

[crossnet]

Graham,

You were absolutely right. Don't know how it happened, but the file was rewritten without the NPVR section when I updated. I restored it and everything is working again. Now I can get past the WAF and really check out the new NPVR. Thank you,

Zeb, It was the IRremote.ini that caused my problem, not the xml. I don't know if there is any connection between these. Good lesson for me to back up everything.

em.