Can not find a scan button

[mkroc]

Hello
New to the forum, but have been using NextPVR in Windows since MCE disco'd. I've been using over the air tuners with no problem.
Running fine.
I'm building a replacement Win11 (thanks again Microsoft)
Installed a USB tuner, it shows "IPTV device" and says I have to use the scan button. 
There does not seem to be a scan button; I have used this tuner before for over the air, so it should be working ok.
The only post I found was someone who only needed IPTV, so the reply simply indicated that IPTV did not need a scan.

Thanks for any directions
mkroc

[mvallevand]

Windows tuners need to have BDA drives installed. Upload your zipped logs and we can check if NextPVR is finding it.

Martin

[mkroc]

>>Windows tuners need to have BDA drives installed. Upload your zipped logs and we can check if NextPVR is finding it.

Martin<<

Logs attached
Thanks

[sub]

You don't have drivers installed for your tv tuner device. Get them from the manufacturer's website.

[mkroc]

Martin 
Thanks for very quick response.
Looks like a bad USB tuner, should have figured when it did not get hot.
Switched to another tuner, 2 tries at the Hauppauge site for driver, but it worked.

Thanks again
mkroc