better Netstream 2000 support??

[sash]

okay i searched your websites for gb-pvr... I only found one mention that fm radio works with pvr350 since I have pvr150mce perhaps it broken for this type of card..

anyways my hardware it
sigmadesigns netstream 2000
hauppauger pvr 150mce
ss2 or twinhan 1020 dvb sat card
matrox video card
netgear wireles network card 802.11b
msi motherboard kt333, 1333 mhz, ~300megs memory

[sub]

I've justed tested it with my PVR350, and its seems to be working fine. The file is only a few hundred kbytes after 20 seconds or so.

I dont have access to a PVR150MCE, so cant test that hardware myself.

[sash]

okay can I ask how this graph is built for fm radio is it auto build or predined..

I will build a few graphs to see how it want to configure itself ... we try some auto build and predefined perhaps it does not like pvr150 tuner card to hook up to the lame encoder

[sash]

okay I tested a few differnt ways with the pvr 150 mce
my assumption you are conneting fm radio this way ( this how it connects properly in pvr 150 and renders fine )

[sub]

From memory, I believe that is how I connect it.

[sash]

okay but I noticed that with the pvr 350 it pins out differently then the pvr 150mce ( posted on a different forum )

example...http://www.8dim.com/forum/topic.asp?TOPIC_ID=1349

so perhaps it expecting to pin out differently and since it does not have the same pins it uses a different method .

but also with the pvr 150 mce ( at least with the netsream 2000 and my driver it can be pined this way)

[sub]

yes, I'm aware of the difference between the PVR150 and PVR350.

I cant wire a graph up like the one your show above, because recording and playback occur in two different processes. The recording service performs the recording part of the process (writing to an mp3 file), and gbpvr.exe plays that file using the file reader, splitter, swapper and decoder.

[sash]

here is an graph for the pvr 150.( the default method using mp3 file). so perhaps this is the problem. with the fm radio.. you could code it to be usable .. ( I tried several clean installs and it always builds the internal graphs for the pvr 150 mce the same way.. on several different machinces . so I would assume everyone using the pvr 150 mce is having the same problem -- in software mode you would not notice because it works somewhat it just produces enormous files but in hardware with the sigma card it does not work)