Live TV stream stops

[VCR58]

When you stream in the web app, it creates a log file in NPVR-data\web\temp. Can zip and attach that log after the web playback stops?

Here is the web/temp log file after the stream stopped. It took about 20 min or so this time. Other times it is only a minute or two and then stops. The CPU usage was at 60%.

Using VLC was better. I let it run for about 45 minutes and it never stopped. Would have let it run longer but I ran out of time.

Thanks for checking on this.

[mvallevand]

Your transcoding drops under 1x speed

frame=16518 fps= 60 q=27.0 size=N/A time=00:04:36.42 bitrate=N/A speed=0.999x

and it can't really keep up after that point.

Martin

[sub]

I think Martin is probably right. There was times in there it just wasn't able to keep up, and this probably screwed you over.

frame=22953 fps= 58 q=34.0 size=N/A time=00:06:23.78 bitrate=N/A speed=0.974x

Ultimately, you're probably better off viewing in a client that doesn't need to transcode video. That said, I am intending to tweak the transcode settings at some stage, to hopefully reduce the transcode CPU requirements a little. I'm also hoping to add hardware accelerated encoding, for those with a video card that support it.

[VCR58]

... That said, I am intending to tweak the transcode settings at some stage, to hopefully reduce the transcode CPU requirements a little. I'm also hoping to add hardware accelerated encoding, for those with a video card that support it.

Ok thanks for looking into this. Maybe those future tweaks and hardware acceleration with keep the speed from dropping below 1x.