Comskip not working on QAM programs

[erik]

I think dvr-ms can't be processed during recording.

Yes it can.
Do scan the readme.txt for dvr-ms

[justinmiller]

Do a recording, then zip and attach your GBPVRRecordingService.exe.log and I'll take a look.

Here you go, thanks Sub!

[sub]

That log doesnt show any recording happening.

[justinmiller]

That log doesnt show any recording happening.

Damn you're too fast! Sorry I just realized that myself, here is the one that does. It recorded the oscars.

[sub]

That one shows a recording, but I need the GBPVRRecordingService.exe.log file, not GBPVRRecordingService.exe-native.log

[justinmiller]

That one shows a recording, but I need the GBPVRRecordingService.exe.log file, not GBPVRRecordingService.exe-native.log

Okay I might just get the hang of this yet.....

[gazoo]

Justin, the postprocessing.bat is on the wiki under comskip I believe. Just drop it in the gbpvr directory and it pretty much acts as if you had ticked the run comskip after commercial box. I ticked it anyway just in case. It will perform commercial skipping on .ts and .dvr-ms - confirmed.

[sub]

According to your logs, it actually ran comskip after the recording:

2008-02-25 22:34:02.656 INFO [15] Running comskip on: C:\Recordings\The Soup Presents\The Soup Presents_20080225_22002230.mpg
2008-02-25 22:37:13.015 INFO [15] Commercial Detection has completed.

It would log an error if it had failed to start comskip.

[justinmiller]

According to your logs, it actually ran comskip after the recording:
It would log an error if it had failed to start comskip.

Thanks Sub. It worked with that recording, as it was an NTSC/mpg recording. But it didn't work with the "Curious George" recordings, those were the dvr-ms recordings. But unless it's obvious to you, I don't want to waste your time, I'll follow gazoo's advice and set up the manual postprocessing.bat.

[sub]

To be honest, I'm not really sure. There isnt enough log messages around that processing to tell what is happening.