i have fine tuned and freqcopy & still no audio

[stefan]

Wow... hauppauge actually trying to solve an issue?

[tubehead]

I tried the drivers that sub mentioned but the results for my setup were less than desirable. I went from no audio on a few channel to nothing anywhere. I was able to back out though to the latest release without issue. The fix Goby posted seems to work for me though Thanks for the post. My offset is about 250000 for each channel that needed it but hey I get audio! Time to start the full season recordings.

[sub]

Thats disappointing to hear. Some other people have had much more success with the drivers, and have indicated it has corrected their audio problems. Oh well, maybe Hauppauge will fix your problems as well with their next drivers.

[buckeye]

Since i started this thread i think i should post a few things
that i learned along the way
A place with the standard cable frequeces

http://www.jneuh

the other thing that i did was going into
config
[INDENT]capture source
[INDENT]edit source[INDENT]then i add 15 "blank channels" [/INDENT][/INDENT][/INDENT]

I used the blank channels to find the correct frequence of the channel

i 1st add 1mhz to each channel up and down
then i added 10,000hz to each channel


I added all the extra channel to save some time that way i could test severl differnt Hz at one time the

make sure that you keep track of them on paper and pen when you are doing it so that you don't get lost

not fast but it worked


I then checked it with Chris tv http://www.chris-tv.com/

very bad imitation of GBPVR but it did tell me that my broadcast was in stereo/mono

[buckeye]

when i added the extra channel
i would add a letter to follow
them so the were 16a 16b 16c....

[buckeye]

Each channel is 6 mhz wide

[buckeye]

THe above link was not complete
here is the one to use

link for the channel frequencies


sorry