Not Finding Devices

[jcole998]

OK! I will give it a try post haste.

Thank you!

JohnC

[mvallevand]

You don't need to edit config.xml that is why I told you to disable the scan on startup.

Martin

[sub]

Oh yeah - I'd forgotten this setting is exposed as a checkbox on the Settings->General page.

[jcole998]

I turned off the startup device scan, stopped the NextPVR service and loaded the CAPTURE_SOURCE table for V6 with rows from V4. Then started the service. Devices were shown as expected so I clicked on device oid 21. That brought me to a new page with a message that no channels were defined for this device. So I clicked on Scan Channels. Got a loading message but no channels were shown. This is when I saved the log files. Seemed like the channel list could not be read.

Should I continue to use the verbose log setting? It was not set for these log files.

JohnC

[mvallevand]

Did you copy the HDHR_RECORDER table as well, it should match the oids in capture source.

Martin

[jcole998]

OK. Filled the V6 HDHR_RECORDER table with data from V4 and adding the IP for each tuner, then restarted the service. Again no channels were shown.

JohnC

[mvallevand]

If the oid's match and the class in v4 was NShared.HDHomeRunRecorder then sub will have to help

Martin

[sub]

You’d probably have to supply the npvr.db3 so I could check what’s wrong with it.

[jcole998]

OK, Martin, thanks. I checked the tables again and oids match and the class is Nshared.HDHomeRunRecorder. The CAPTURE_SOURCE table shows all three tuners present and enabled.

I hope sub is not too busy.8)

JohnC

[jcole998]

OK, sub. File attached.

JohnC