Problem with Fusion cards and Channel Scanning, No Pins on tuner

[doogle]

I know there are have been threads about this before but I can't find an answer to this particular problem.
I have been using GBPVR for over a year with no problems, fabulous piece of software.
I had been using XP sp2, with two fusion cards with no problems.
Then my system drive died (had a backup but looong story).

So I rebuild using Windows MCE ( mainly out of interest).
Reinstalled everything.

BUT GBPVR won't find any channels when I scan.
Fusion software works OK.
Got the cyberlink muxer,
Intervideo codecs.

Looking at Config.exe-native.log you can see that the fusion drivers were found OK but there is a failure with the ConnectPins.

Anyone else seen this ??


20:46:54.640 VERBOSE - FusionHDTV, Transport Stream Capture
20:46:54.640 VERBOSE Successfully auto detected tuner filter: FusionHDTV, Transport Stream Capture
20:46:54.640 VERBOSE ConnectPins: 'MPEG2 Transport' to 'MPEG-2 Stream'
20:46:54.687 VERBOSE ConnectPins failed: hr = 80040217
20:46:54.687 VERBOSE Demux filter has the following default output pins:
20:46:54.687 VERBOSE About to try to add VMR9 preview

Used graphedit to view the bda drivers and the tuner doesn't have any output pins !!


[ATTACHMENT NOT FOUND]

[ATTACHMENT NOT FOUND]

[ATTACHMENT NOT FOUND]

[sub]

Some BDA drivers wont create the output pin until you connect the ATSC Network Provider to its input. Try it.

Anyone else seen this ??

20:46:54.640 VERBOSE - FusionHDTV, Transport Stream Capture
20:46:54.640 VERBOSE Successfully auto detected tuner filter: FusionHDTV, Transport Stream Capture
20:46:54.640 VERBOSE ConnectPins: 'MPEG2 Transport' to 'MPEG-2 Stream'
20:46:54.687 VERBOSE ConnectPins failed: hr = 80040217
20:46:54.687 VERBOSE Demux filter has the following default output pins:
20:46:54.687 VERBOSE About to try to add VMR9 preview

I think you were on th right track. It sounds like the output pin name is not correct.