2006-08-08, 09:32 PM
Ok, I've searched for this first off, but either i'm blind or its not been asked.
How can I setup gbpvr w/mvp so that when I:
1) Show the channel number when I change channels and
2) Show the numbers I'm entering to manually go to a channel.
I'm using the PVR500 with the InterVideo NonCSS decoders, VMR9, and Minimal OSD settings.
How can I setup gbpvr w/mvp so that when I:
1) Show the channel number when I change channels and
2) Show the numbers I'm entering to manually go to a channel.
I'm using the PVR500 with the InterVideo NonCSS decoders, VMR9, and Minimal OSD settings.