2006-08-29, 02:52 AM
I tried looking through the forum and could not find anything about my problem... I have a Dvico Fusion5 RT gold and I was able to update the EPG using zap2it and find the card using the settings but then when I try to map the channels I get "GB-PVT was unable to start the DBA device you have configured. Check the device is configured properly, and not already in use" There do not seem to be too many options in the configuration, everything is greyed out except the device number, country and region and country and region only have one option. Using the dvico software I was able to get it to work just fine, but I get this for this program so I unistalled the Dvico to make sure it was not using it. In the status I get that the card is asleep and in Mux Checker I get "NO MULTIPLEXER FILTERS WHERE FOUND ON YOUR MACHINE." I have Power DVD installed on the computer with MPEG2 decoders not sure about encoders, but I would think Dvico would install that... not sure if this is two problems or one.. please send me some help.. thanks