2007-01-25, 03:48 PM
My system: Hauppauge PVR150 USA I have Zap2it and I am able to update the EPG.
First of all I am a noob talk to me like I am dumb. I am trying to figure out what is going on with my live TV channels.I am able to see all channels perfectly in WinTV2000 but not in GBPVR. I do not use a set top box it is connected directly into my PVR card.I use the 45 button controller that comes with the card I have done the fix button for it and it seems to work correctly for everything I have tried so far.
The first 10 or so channels come in fine with a few in between them that fuzz out, but the higher I go the worse it gets. They get staticy out of tune and no volume. I have tried to use Freq copy and it did not work it created the registry group but did not assign any values to the channels. I have used the tunning assistant and gotten some frequency numbers. I see where you can edit the channels in the channel config area but I have not found out what format you are supposed to put them in I saw one example that was ###,### but my freqs from Tunning assistant are 8 numbers long.
Under Hauppauges channels each entry reads like this
Name Type Value 1_0_8_1_1_10 reg_binary a long hex value
Under TVServices created by FreqCopy
Name Type Data
10 Reg DWord 00x00000
This is like this all the way down now the last numbers in hauppauge match exactly to the names in TVServices. in TV Services I tried modifying the registry Data section to accept a decimal of the frequency from Tunning assistant so I selected decimal and input the 8 digit number. No go on that though. I also went into the edit channels under the capture source and put in the first 6 characters in the channel box that didnt work though. The only thing I can think of is there a service that needs to be restarted or something after making the registry changes or is my formatting off or am I way off. Thanks for looking at this.
First of all I am a noob talk to me like I am dumb. I am trying to figure out what is going on with my live TV channels.I am able to see all channels perfectly in WinTV2000 but not in GBPVR. I do not use a set top box it is connected directly into my PVR card.I use the 45 button controller that comes with the card I have done the fix button for it and it seems to work correctly for everything I have tried so far.
The first 10 or so channels come in fine with a few in between them that fuzz out, but the higher I go the worse it gets. They get staticy out of tune and no volume. I have tried to use Freq copy and it did not work it created the registry group but did not assign any values to the channels. I have used the tunning assistant and gotten some frequency numbers. I see where you can edit the channels in the channel config area but I have not found out what format you are supposed to put them in I saw one example that was ###,### but my freqs from Tunning assistant are 8 numbers long.
Under Hauppauges channels each entry reads like this
Name Type Value 1_0_8_1_1_10 reg_binary a long hex value
Under TVServices created by FreqCopy
Name Type Data
10 Reg DWord 00x00000
This is like this all the way down now the last numbers in hauppauge match exactly to the names in TVServices. in TV Services I tried modifying the registry Data section to accept a decimal of the frequency from Tunning assistant so I selected decimal and input the 8 digit number. No go on that though. I also went into the edit channels under the capture source and put in the first 6 characters in the channel box that didnt work though. The only thing I can think of is there a service that needs to be restarted or something after making the registry changes or is my formatting off or am I way off. Thanks for looking at this.
