VAPanel showing conflicts on client?

[dark_half]

On my server the conflicts are seen when using the VApanel on the main menu. What do I have to change to have it show up on the client?

[Jeff]

The settings for the server and clients are independently configured. On the client you need to run the config program and configure the panel. One of the panel widgets is to show conflicts.

[dark_half]

I have it set to show conflicts but it never does. Does it use the database to get conflict information? If so where does it get the database location from?

[Jeff]

It should be pulling them from the main gbpvr database on the server. I haven't tested that function on the client so maybe I have an error.

Jeff

[dark_half]

If I change the location of the database to point to the server in config.xml on the client then it appears to work. I just am not sure if this has any side affects on the operation of GBPVR while in client mode.

[Jeff]

I found a few places in the code where I was not looking at the server when I should have been. I have changed these for the next release.

Jeff

[dark_half]

Thank you