2007-02-16, 07:36 PM
I've had a Hauppauge WinTV PVR USB2 for several weeks now and have settled on the GBPVR software. It is wonderfully configurable and customizable! And this support forum is the best!
On to my problem and question...
I have the MCE version of the USB2 so I configured GBPVR to use the MCE Remote. The supplied IR blaster works fine, but my STB uses an RF remote, so I don't need the blaster for that purpose. When I remove the IR blaster completely and try to use the USB2 built-in IR receiver, the remote commands aren't received. What do I need to do to enable/configure the built-in IR receiver?
Thanks sub and ALL forum members for taking the time to help each other out.
Pete
On to my problem and question...
I have the MCE version of the USB2 so I configured GBPVR to use the MCE Remote. The supplied IR blaster works fine, but my STB uses an RF remote, so I don't need the blaster for that purpose. When I remove the IR blaster completely and try to use the USB2 built-in IR receiver, the remote commands aren't received. What do I need to do to enable/configure the built-in IR receiver?
Thanks sub and ALL forum members for taking the time to help each other out.
Pete