Log file fills up the hard drive

[sub]

Enable log flushing in the config app, then schedule three recordings for the same time, then zip and attach the logs and I'll take a look.

[boxxed]

ok, but thats it. I cant record 3 programs a the same time. The mvp tells me there was a conflict, acting as if there is only one card. If I click on the little icon in the task bar- recording status, it tells me that the 350 in recordng and that the 500's are sleeping.

Thank you.

[sub]

ok, but thats it. I cant record 3 programs a the same time. The mvp tells me there was a conflict, acting as if there is only one card.

I have no idea what you are trying to say. Give it to me again in more detail.

[boxxed]

Ok, i'll try again. I have 2 cards installed in my machine. One Hauppauge 350 and 1 Hauppauge 500. Therefore I should be able to record 3 tv programs at any given time. However, when I try to record more 2 shows at the same time the MVP seems to think I only have the 350. However, the gbpvr software seems to know of both cards.

Sorry for being so confusing.

[sub]

Try scheduling them, then zip and attach the logs and I'll take a look.

[boxxed]

I cant schedule multiple recordings at the same time. It tells me there is a recording conflict. I have removed the 350 and just used the 500. It works just like it is supposed to. I can reocord 2 programs at the same time with no problems with the 500. I can remove that card put back in the 350 and it works like it is supposed to. Then I try to use both cards at the same time and it does not allow me to record 2 or more shows at the same time. It gives me the recording conflict message. I have tried moving them around n my pc. Does not matter.

[sub]

I cant schedule multiple recordings at the same time. It tells me there is a recording conflict

Thats enough to tell me what I want in the logs. I cant do anything if you dont supply logs.

Its just a matter of correctly creating three capture sources, with the correct devices numbers, all using the same EPG source.

[boxxed]

I hope this is right... Also, I haver change the device order around many different ways..Still no avail.


Thank you again.

[sub]

2007-09-20 23:32:21.609 VERBOSE [1] Possible capture device: DEVICE:Hauppauge PVR350:1
2007-09-20 23:32:21.609 VERBOSE [1] Possible capture device: DEVICE:Hauppauge PVR500 with FM tuner:1

I can see you have your 'Hauppauge PVR350' capture source set as device #1, and your 'Hauppauge PVR500 with FM tuner' also set as device #1. This is wrong.

You need to have three capture sources. One for the PVR350 and two fo the PVR500. The device numbers for these capture sources will either be #1 for the PVR350, and #2 & #3 for the PVR500s.... or #1 & #2 for the PVR500s and #3 for the PVR350.

[boxxed]

I understand what you are saying. You went throught this with me before. So This time I have made sure each card had its own caputer device number. My 350 is set up as #3 and the 500 with fm tuner is #1 and the other 500 is #2 That is the way it is set up in the "Capture sources device tab under recording sources. Is there another way to change the the softwtare looks at the cards?