Hauppauge remote

[sean]

I just upgrade to 9010 and still my remote is not working. It works for 50 or 60 minutes then stops. I do a restart on the irremote and I get an error message stating that it failed to initialize hardware. It does work longer on this version then the previous one. What should I try? The only way to get it to work in a restart.

Configuration
Under recording source I have no channel changer required. If I select this the remote never works.
Under the misc tab I have use direct access to Hauppauge remote checked
And remote control type default Hauppauge.

I am not sure if this is the new 45 button remote or not it has 4 color buttons at the bottom.

[sub]

This isnt a GB-PVR problem. Its a problem with the Hauppauge IR software. There is on going discussion on this topic at http://www.shspvr.com/forum

[capone]

I had some info that might help. Had same prob and fixed it.

http://gbpvr.com/cgi-bin/ikonboard.cgi?a...f=2;t=3905

[sean]

Thanks for you help. the remote has been working for 3 days strait now.

[flarf]

Anybody have the solution to this? I have the same problem, but the link above is dead.

[flarf]

Nevermind, I uninstalled everything (GBPVR and PVR250 drivers using the instructions at http://www.hauppauge.com/Pages/support/s...0.html#app) Installed the drivers and all Hauppauge provided apps, THEN installed GBPVR and the remote works fine.

[mlanglois]

I have the same pb with the 45 button Hauppauge remote, but the link posted above is dead, so I don't know how to solve the pb!

I don't want to reinstall everything, so please help!

[mlanglois]

I've downloaded version 2.0.24.23035 as indicated in other forums, and so far the remote pb is gone.