GB-PVR shows signal strength (ATSC), but registers no channel

[ssmhon]

Not sure how to search for this issue I have, so perhaps a new thread if anybody have encountered this and found a solution? I've just reinstalled my OS and reinstalled GB-PVR since I've gotten a 2nd HVR-1600. Both analog tuners on the cards work flawlessly, but both digital tuners are not registering any channel even though GB-PVR is reporting signal strengths and qualities at the right bands. Any ideas?

TIA!

[sub]

Do a scan then zip and attach the logs and I'll see if I can see anything.

[ssmhon]

Here're the logs that have been changed/created when I did a scan. Hope these can help with your diagnosis!

[sub]

Can you see if the attached file makes any difference? If not, then zip and attach the config.exe-native.log it produces when you do a channel scan (there are some new log messages I'd like to see).

[ssmhon]

This is fantastic! It works! Does it mean that whenever I have more than 1 ATSC tuners (or is it more specifically more than one HVR-1600?) I'd need to use this DLL instead of the one bundled in the installation .msi?

[sub]

You'll only need to apply that DLL again if you reinstall before the next release. After then it'll be included.

The bug only affected a small percentage of dual tuner users.

[ssmhon]

I see. Thank you again for the good work!

[phatttty]

Sorry for the dumb question, but how do you do a channel scan?

[sub]

A scan starts when you click the 'map digital channels to epg channels' button on a BDA capture source.