Last weekend Beloved turned off our mediacenter by pressing the power-button, which switches the machine to standby. She actually wanted to run it on, but didn't look at the display (shows clock when turned on). Unfortunately, there were two programs being recorded, which are now a bit messed up. Good thing is, she realizes it's her own fault and doesn't complain to me
Then she asked me: "how can I see that it is recording?" and my answers are a bit vague at best (we're using PVRx2):
* the hard-disk light is blinking at a steady rate
* it is shown when looking at the pending recordings
Is there another, better way to check this? I know that GB-PVR showed recording status on the main menu. Is it possible to get this in PVRx2 as well?
Then she asked me: "how can I see that it is recording?" and my answers are a bit vague at best (we're using PVRx2):
* the hard-disk light is blinking at a steady rate
* it is shown when looking at the pending recordings
Is there another, better way to check this? I know that GB-PVR showed recording status on the main menu. Is it possible to get this in PVRx2 as well?
[SIZE="1"]
HW: Asus M2NPV-VM (nVidia 6150/430 chipset), AMD Athlon64 3200+, 2x512MB Kingston ValueRAM, Samsung 250GB HDD, 2x Hauppauge PVR 150MCE, Pioneer DVR-111D, Seasonic S12-330 PSU, Silverstone LC10B-M case, Zalman 7500-AlCu fan
SW: XP Pro (SP2), PVRX2 (1.2.9), NVidia (163.71), Hauppauge (2.0.48.24227). MPV/MPA Decoders
[/SIZE]
HW: Asus M2NPV-VM (nVidia 6150/430 chipset), AMD Athlon64 3200+, 2x512MB Kingston ValueRAM, Samsung 250GB HDD, 2x Hauppauge PVR 150MCE, Pioneer DVR-111D, Seasonic S12-330 PSU, Silverstone LC10B-M case, Zalman 7500-AlCu fan
SW: XP Pro (SP2), PVRX2 (1.2.9), NVidia (163.71), Hauppauge (2.0.48.24227). MPV/MPA Decoders
[/SIZE]