Choice of MPEG mux

[cpf]

I have both Cyberlink and ATI MPEG muxes installed on my system. Is there any way of specifying which one should be used for transcoding DVR-MS?

[sub]

When transcoding from DVR-MS it always uses the Cyberlink mux.

[cpf]

OK, I got the impression it could now use the ATI from the Processing tab in Config - it says "Please note, the Cyberlink or ATI MPEG Mux is required to convert DVR-MS file". I think the mention of ATI was added quite recently.

Are there any plans to make the ATI mux useable? I'm interested because I sometimes get strange playback glitches after remuxing with the Cyberlink, and I'd like to try the ATI to see if it's any better.

[sub]

OK, I got the impression it could now use the ATI from the Processing tab in Config - it says "Please note, the Cyberlink or ATI MPEG Mux is required to convert DVR-MS file". I think the mention of ATI was added quite recently.

That mux choice is just used at recording time, not for converting DVR-MS files after the fact.

Are there any plans to make the ATI mux useable? I'm interested because I sometimes get strange playback glitches after remuxing with the Cyberlink, and I'd like to try the ATI to see if it's any better.

I didnt have any immediate plans to do this, but maybe in the future.

[sub]

While you wait to see if I get around to changing this , you might want to check out the discussion here: http://forums.nextpvr.com/showthread.php?t=33243&page=3