Leadtek PVR2000 not working

[joeboo]

Hi,

I purchased a Leadtek Winfast PVR2000 as I saw it on the list of supported cards. However, when I try to watch Live TV I receive a divide by 0 error. Am I doing something wrong or is this card not really supported. After buying the card I read somewhere in this forum that the Leadtek card might not support Live TV. If this is true then I would suggest removing it from list of supported hardware.

That said, I would still like to get this working, so back to my original problem did I miss something in the setup.

BTW the card works fine with the software from Leadtek, but, the software is quite limited in its functionallity.

Thanks,

Joe

[sub]

I actually might be removing the PVR2000 from the supported list next time I update it. I dont think it works any more with latest versions.

There is two things you could try.

1) Make sure have the EPG setup and have channels listed in the config app. Without this, there is a bug in the last release that can cause a divide by 0 error.

2) Disable the 'live preview mode' on the 'misc' tab of the config app.

[ice_o]

sub
Do not remove PVR2000. I hope, it is possible to find the solution of Live TV.
Yesterday, I try to upgrade to new PVR2000 drivers without success.
But Live TV began to work.

[Fulir]

Once again: my PVR2000 IS working fine