didnt record second show

[dc9mm]

Running latest GBPVR 1.2.13
I had GBPVR set to record Greys Anatomy and Life on mars both on same channel 7. Had two problems. Right near the end of first show at about 9:58m computer shut off. I think that was maybe caused because i had update EPG set at 10pm not sure if that would cause problem. I forgot to set the update EPG back to 6pm were I normally keep it set at.
Restarted computer, then started GBPVR went to shows pending and it was now recording Greys Anatomy which ended at 10:01pm and Life on Mars started at 10:01 same channel. At this point i watched at 10:01pm it switched now showing that it now was recording Life On Mars. So i thought all was fine. Now after recording it was over it now only shows Greys Anatomy was recorded no Life On Mars. I looked at the folder were the shows are stored after recording and GBPVR made a folder for Life On Mars but nothing in it. I attached all the log files in a zip file.
I have Comskip installed set to remove commercials after recording is done, latest version I just got in last week

[dc9mm]

Again it doesnt record the second show. I used TV guide set it to record to 1/2 hour shows on same channel that fowolled each other. It records first show ok but doesnt record the next half hour show. Only thing i can think of is comskip that removes commercials after its done recording. I guess i will remove comskip and see if it still occurs. I wish i new how to read the log files as that might clue me into whats going on. How do i reasd log files Is there a program that reads files with a file extension log.

I again attached log files zipped.

[erik]

Comskip does not remove commercials, it only create a file that tells where the commercials can be found

[Graham]

Is there a program that reads files with a file extension log.

They are text files. Notepad will do it.

Good Luck

[Carlito]

Do you have 2 tuners installed? it looks like it's trying to send the second show to a second tuner and then it fails to find said tuner.
Check to make sure you're capture sources are set up properly in config.

[dc9mm]

Do you have 2 tuners installed? it looks like it's trying to send the second show to a second tuner and then it fails to find said tuner.
Check to make sure you're capture sources are set up properly in config.

Thats it!
Ok iam an idiot. I removed the one capture card for another reason BUT i never removed it from the config setup. So i caused the problem. Boy do i feel stupid. Thanks for the help guys.