2005-03-29, 08:25 AM
Hi to all gbPVR users out there!
Finally I built up my new machine, which I am proud of. Here it is:
Aopen Board, Celeron M, 512 MB DDR, 160 GB HDD (5400 rpm)
Hauppauge PVR 150, XCard (cool )
Win XP SP 2
no monitor, just the TV-set
Nearly everthing works fine (but it's still being developed).
Now my question:
The machine goes to hibernate perfectly and wakes up right in time to do some recordings (which I couldn't believe until I saw it ) - but...
...when the gbPVR screen is displayed on the TV-set when the machine goes to hibernate, it will not be displayed again on the XCard's TV-out after wake-up. When I exit and re-start gbPVR, the XCard works fine.
...so I could exit the gbPVR screen (i.e. stop gbPVR) after finishing watching, then the machine goes to hibernate after the configured time... but how to re-start gbPVR again after wake-up? Is there any possibility to start a program (in this case gbPVR) automatically after wake-up from hibernate? Or can I start it via the remote?
...in this case I would appreciate a possibility that automatically exits gbPVR before going to hibernate, in order not to wake up with gbPVR running (which leads to no gbPVR screen on the TV set).
How should gbPVR be used, particularly: *started* and *stopped* if one does not use a monitor?
I would really appreciate any answers and experiences...
Greetings, Alex
Finally I built up my new machine, which I am proud of. Here it is:
Aopen Board, Celeron M, 512 MB DDR, 160 GB HDD (5400 rpm)
Hauppauge PVR 150, XCard (cool )
Win XP SP 2
no monitor, just the TV-set
Nearly everthing works fine (but it's still being developed).
Now my question:
The machine goes to hibernate perfectly and wakes up right in time to do some recordings (which I couldn't believe until I saw it ) - but...
...when the gbPVR screen is displayed on the TV-set when the machine goes to hibernate, it will not be displayed again on the XCard's TV-out after wake-up. When I exit and re-start gbPVR, the XCard works fine.
...so I could exit the gbPVR screen (i.e. stop gbPVR) after finishing watching, then the machine goes to hibernate after the configured time... but how to re-start gbPVR again after wake-up? Is there any possibility to start a program (in this case gbPVR) automatically after wake-up from hibernate? Or can I start it via the remote?
...in this case I would appreciate a possibility that automatically exits gbPVR before going to hibernate, in order not to wake up with gbPVR running (which leads to no gbPVR screen on the TV set).
How should gbPVR be used, particularly: *started* and *stopped* if one does not use a monitor?
I would really appreciate any answers and experiences...
Greetings, Alex