new install - channel change prob

[Gerald]

After doing a new install i copied gbpvr.db3and config.xml across from previous install. I setup HIP again.

1.) Now in GBPVR any buttons pressed on MCE remote causes double movements in GBPVR. ... ie down arrow causes 2x movements

2.) No channel changes happens on STB --- nothing been sent to HIP.

If i disable hip then MCS remote still works in GBPVR. Looks like GBPVR recognises the MCE remote even though channel change is set to .exeplugin.
I have uninstalled, renamed GBPVR folder and installed fresh again. Set to no channel changer, but still GBPVR responds to MCE remote.

Any ideas where i have gone wrong?

I am using an MCE remote and HIP for channel changing of my STB. If there is another way to do it directly from GBPVR please suggest.

Thanks ..

[pBS]

run the batch file in codebox on this page...should do the trick..
http://forums.gbpvr.com/showpost.php?p=3...ostcount=1