2009-07-28, 08:35 PM
Hi,
Just bought and installed the TechniSat SkyStar HD2 card. Have just watched 'Coast' on BBC HD and it looked great viewing it via the "DVBViewer TE2" software that came with the installation disk - so i know my satellite signal and dish are fine. I now want to use GB-PVR with this card so have just tried to set it up but when i hit the "Map Digital Channels to EPG Channels" i get an error "GB-PVR was unable to start the BDA device you have configured. Check the device is configured properly and not already in use". I've uninstalled the "DVBViewer TE2" software (in case that was causing a conflict) and the setup in GB-PVR still fails with the same error. Any ideas anyone? Hopefully i've attached the right files to help.
Thanks in advance
Whitters
Just bought and installed the TechniSat SkyStar HD2 card. Have just watched 'Coast' on BBC HD and it looked great viewing it via the "DVBViewer TE2" software that came with the installation disk - so i know my satellite signal and dish are fine. I now want to use GB-PVR with this card so have just tried to set it up but when i hit the "Map Digital Channels to EPG Channels" i get an error "GB-PVR was unable to start the BDA device you have configured. Check the device is configured properly and not already in use". I've uninstalled the "DVBViewer TE2" software (in case that was causing a conflict) and the setup in GB-PVR still fails with the same error. Any ideas anyone? Hopefully i've attached the right files to help.
Thanks in advance
Whitters