GB-PVR and EPG Sync.

[doron_amedey]

hello friends,

I have a strange problem,
i have HAP 150 card with the 45 keys remote.
the problem that i have is:
when i download the EPG, i can see that it reads it well, but it gives incorrect numbers to the statations, and if i choose from epg a program on fox, it moves me to mtv (i.e. only).
i don't know how to work this around.
can anyone please advise if they had the same problem how did they fix it?
thanks.

[sub]

Sounds like you've got the wrong channel numbers listed against the channels in you capture source settings.

[doron_amedey]

Yes, you are right.
the problem is that i dont know where to fix it.
i fixed the channels to the correct ones in the channels tab, but i still get them wrong.
(in the capture source, if i correct the channels, once i press update to update the epg, its all going back to the original <-- wrongs channels).
can anyone please advice on how to fix this?
thanks.

[stefan]

To the far right in the config app, there is a tab called "channel numbers" or something like that.

[onestar]

Yes, you are right.
the problem is that i dont know where to fix it.
i fixed the channels to the correct ones in the channels tab, but i still get them wrong.
(in the capture source, if i correct the channels, once i press update to update the epg, its all going back to the original <-- wrongs channels).
can anyone please advice on how to fix this?
thanks.

Channel tab, numbers represent the order number.
Capture source, the numbers represent the channel number if used with the channel changer.

Once you have changed them do they go back to the original settings, or do you now have 2 sets of channels ? I ask because early on I remember getting channels 1-5 always reappearing as 1-5 because in the xmltv feed the channel names were BBC1 and 1 and Five and 5.

[doron_amedey]

thank you friends,

when i sync. the channels to the right numbers in the channels tab, it has no effect.
i believe the sw looks at the capture tab only.
since i have sattelite subscription, so i use the ir blaster to switch channels.
if i change the channels on the capture mode, it works fine, but when i refresh the epg, i get the same problem again, since the channels are been re-arranged again.
please help me with any directions /ideas...

[PixelPusher]

When in interactive mode, I am able to change channels through the guide and it works properly. When I schedule a recording it always records some other channel. Any ideas why this might happen? (I have done 10 or so scheduled recordings and only one worked.)

-Eric

[doron_amedey]

is there a way to move in a program that i recorded to specific place by moving the time line? or just ff and to wait for the starting point?

[sub]

is there a way to move in a program that i recorded to specific place by moving the time line? or just ff and to wait for the starting point?

I dont know what this has to do with the topic you posted in...

The time line only give you a visual indication of where playback is up to. You cant interact with it. If you want to jump forward 5 minutes, just type 5 then press the skip key.

[doron_amedey]

thank you for the help with the timeline. and you are right i should have posted it in new thread.
as for the main problem i have, i still could not solve it.
can anyone help me please?