Channels Sometimes Skipped When Mapping Digital Channels To EPG

[skycyclepilot]

Once I have GBPVR installed, and I am setting up my capture sources, when I go to map my digital channels to the EPG, groups of channels will sometimes get skipped, and I have to rescan. It takes three or four rescans before all the channels are detected properly.

The quality rating on the channels shows up as 100, and the signal strength is -20.

I'm using an HVR2250 on Windows 7 x64.

[whurlston]

In config.xml. change the following settings:

Code:

<BDAPsiScanStartupSeconds>5</BDAPsiScanStartupSeconds>
  <BDAPsiScanWaitSeconds>25</BDAPsiScanWaitSeconds>

Make sure to use notepad and not wordpad.

[skycyclepilot]

Thanks! I was able to complete the installation, but I've added this information to my notes for the next time I have to install GBPVR.