Device setup copy

[Graham]

I use UK DVB-T. Device setup and scanning works really well. Huge improvement on PVRX2.

A message pops up asking me if I want top copy an existing device. This is good.

But ...

I can't force a copy after a rescan. My vote would be for Copy and Paste buttons at the bottom of the Devices tab page.

[Reddwarf]

I use UK DVB-T. Device setup and scanning works really well. Huge improvement on PVRX2.

A message pops up asking me if I want top copy an existing device. This is good.

But ...

I can't force a copy after a rescan. My vote would be for Copy and Paste buttons at the bottom of the Devices tab page.

You can delete all channels from the device you want to copy to, when you start setting it up again it should ask if you want to copy.

[sub]

It'll only ask you this question when you go into a capture source that has no channels setup (and you've got another capture source of the same type that has been setup). As soon as you've added some channels to that capture source you'll never see the message again.

As Reddwarf said, if you want to make it ask again at a later date, just delete the channels associated with the target capture source.

[Graham]

... just delete the channels associated with the target capture source.

Hmmn ... I spose I can cope with that and, since you're the boss, I'll have to.

Thanks.